Dear Readers,
This website provides information about traveling in Raja Ampat and West Papua as a whole. Tourism sector has collapsed due to the limitations of people's movements during this covid pandemic. A lot of guides have become unemployed.
Please, support me in continuing these works by sending your donation through Western Union to my address:
Leo Charles Roring
Jl. Brawijaya, samping SD Padma 1
Kompleks Missi, Manokwari 98311
Provinsi Papua Barat
Indonesia
After that, you could send the MTCN (Money Transfer Code Number) to my email: peace4wp@gmail.com or to my whatsapp: +6281332245180.

Thank you,


Charles Roring
rajaampat.club

Tuesday, September 27, 2011

Cargo Ship and Phinisi Boat Just Outside Manokwari bay

Last month I shot a cargo ship and a phinisi wooden boat just outside Manokwari bay using my camera Nikon Coolpix P500. I was amazed to see that the traditional Phinisi boat which was considered slower than the steel ship could chase the modern cargo ship. At first, the phinisi boat was behind the cargo ship. It was not moving on the water with sails but wit propeller. In fact, both of them were using marine screw propellers.
The phinisi sailing boat was not a cargo boat. It was a diving boat. So, it was quite empty, I guess. On the other hand, the cargo ship, perhaps, was loaded with goods which made her movement slower due to more water resistant. In less than 5 minutes, the phinisi boat was able to chase the cargo ship.
Later, the phinisi boat was at the front of the cargo ship. This is an interesting scene for me because most of us consider a wooden sailing boat like Phinisi slower than the cargo ship. In reality, it is faster - if it is equipped with marine diesel engine that drives a screw propeller. Another factor which makes the boat faster is her smaller block coefficient. The smaller the block coefficient, the faster it will be when moving on the surface of the water. 
Wooden boats frequently experience water leakages in the stern tube area near the propeller. Traditional boat builder in Indonesia do not use lignum vitae as bearing materials. They have certain kind of wood that has properties similar to the lignum vitae. However, the wood has to be frequently replaced to prevent sea water from entering the hull through gaps between the propeller shaft and the stern tube bearings. 
Modern design sterntube bearing uses seals and oil around tail shaft inside metal bearings with higher pressure to prevent sea water from entering the sterntube. - by Charles Roring

1 comment:

Anonymous said...

this is a real of acts,so pinisi is made of high speed and good balance and one of wonderfull ship architecture in the world